|
此文章由 radonradon 原创或转贴,不代表本站立场和观点,版权归 oursteps.com.au 和作者 radonradon 所有!转贴必须注明作者、出处和本声明,并保持内容完整
If the engine speed becomes unstable after the battery is replaced, reset the engine using the following method:
1. Stop the vehicle in a safe place.
2. Place the gearshift lever (manual transmission) in the ”N” (Neutral) or the selector lever (automatic transmission) in the ”P” (PARK) position. Stop the engine.
3. Restart the engine.
4. Turn off the air conditioning (if so equipped).
5. Allow the engine to warm up until the needle in the water temperature gauge stabilizes near the centre of the gauge.
6. Stop and restart the engine.
7. Allow the engine to idle for approximately 10 minutes.
8. When the engine speed stabilizes, the resetting procedure is complete.
NOTE
If the engine speed remains unstable after the resetting procedure has been performed, have the vehicle inspected by an authorized MITSUBISHI dealer.
什么原理? |
|