一篇给想建房的童鞋的帮助帖子,开始现场直播一个SPEC HOME的建造过程.8月19日，已更新

a-spec

这个一定要加分拉！！！

nz-au

楼主好人，定要帮顶。无分可加，顶贴补上。

cyvs

travelangler 发表于 2013-6-26 20:09
地基: (这篇里面的FOUNDATION 是传统的SLAB, WAFFLE SLAB,大同小异)

现在房子的PREPARATION LEVER,已经做 ...

LZ 我可以问你对这个设计的意见吗？

The Soil Report said

"The boreholes revealed a soil profile consisting of the following:
• 400mm of Brown/Grey/Orange FILL (Mix of Clayey SILT & Silty CLAY) overlying
• 500mm of Grey/Brown Clayey SILT overlying
• Orange/Grey Silty CLAY"

The engineer specifies the edge beam to be 300W x 600 MIN D. + 3-L12TM BTM.   

这个design足够吗？

travelangler

It is sufficient,very standard design for edge beam, what is the recommended finding depth on soil report

travelangler

cyvs 发表于 2013-7-1 23:01
LZ 我可以问你对这个设计的意见吗？

The Soil Report said

It is sufficient,very standard design for edge beam, what is the recommended finding depth on soil report

travelangler

cyvs 发表于 2013-7-1 23:01
LZ 我可以问你对这个设计的意见吗？

The Soil Report said

Whatever the recommended finding depth is, you should always go 100mm into the orange silt clay

cyvs

travelangler 发表于 2013-7-1 23:05
It is sufficient,very standard design for edge beam, what is the recommended finding depth on soil r ...

The minimum founding depth of edge beam is 500mm.  For strip and stump footing, it recommends 1M.

If I am going into the Orange clay, then the edge beam needs to go to 1M?

cyvs

travelangler 发表于 2013-7-1 23:08
Whatever the recommended finding depth is, you should always go 100mm into the orange silt clay

From the engineering drawing, it looks like the engineer has specified a blinding concrete depth of 400mm to go into the orange/gray silty soil.  Would this be equivalent of 1000mm of edge beam depth?

travelangler

The edge beam depth is always 600， you may need to go down to 1m to find the orange, then you need pour 400mm blinding,let it dry , then you edge beam will sit on top the blinding, blinding will transfer the load to the solid orange load bearing clay

travelangler

cyvs 发表于 2013-7-1 23:33
From the engineering drawing, it looks like the engineer has specified a blinding concrete depth o ...

The edge beam depth is always 600， you may need to go down to 1m to find the orange, then you need pour 400mm blinding,let it dry , then you edge beam will sit on top the blinding, blinding will transfer the load to the solid orange load bearing clay

Your engineer sounds right about 400blinding

Lovemilo

谢谢分享。

googlemap

请教一下LZ怎样判断architect 和structure engineer的好坏呢?

建新房子的能量评估是哪一位做的呢?

rdlcs

好多坑没填，等

travelangler

googlemap 发表于 2013-7-8 19:30
请教一下LZ怎样判断architect 和structure engineer的好坏呢?

建新房子的能量评估是哪一位做的呢? ...

Architect 和ENGINEER的好坏,如果没有一定的专业知识和经验,比较难判断,最好请教从事这方面的朋友或者专家

能量评估有专门做ENERGY RATING的公司去做的,通常由ARCHITECTS ENGAGE

travelangler

rdlcs 发表于 2013-7-8 19:38
好多坑没填，等

开始填了,以一个新的方式