|
|
此文章由 liforent 原创或转贴，不代表本站立场和观点，版权归 oursteps.com.au 和作者 liforent 所有！转贴必须注明作者、出处和本声明，并保持内容完整
本帖最后由 liforent 于 2018-5-7 16:32 编辑
谢谢上楼。我查了一下，发现了这个标准（来自http://www.build.com.au/bathroom-waterproofing）：
Waterproofing rules and regulations
There are regulations in place that your waterproofing will need to comply with, as set out by the Building Code of Australia and Australian Standards (AS 3740-1994). In short, they require that:
In the shower, the whole floor must be waterproof and the shower walls should be waterproofed up to 1800mm.
The walls need to be waterproofed up to 150mm.
If the bathroom floor is made of or contains wood or if the bathroom is on the second story or higher, the whole floor must be waterproofed.
Over the step down to the floor should be waterproofed to 100mm.
These are the minimum requirements, but depending on your needs, you may also want to waterproof the areas around the bath, toilet and vanity unit. |
|
分辨率画廊今夜开张 (2007-8-23) 分辨率 
发表于 2018-5-6 20:41
