|
|
此文章由 xzt090 原创或转贴，不代表本站立场和观点，版权归 oursteps.com.au 和作者 xzt090 所有！转贴必须注明作者、出处和本声明，并保持内容完整
实在不能理解DODO的做法， 在没有买他们的ROUTER情况下，我已经成功能用到NBN，把操作给大家COPY下，谢谢大家，明天准备complain DODO
You can get the modem connection username and password by clicking forgot password link in the dodo.com.au personal login page. It comes to your mobile phone as a text message. Reset your new router, connect the main RJ 45 cable comes from the NTD to the Gigabit WAN port of your new router. Turn the router on. Connect to it wirelessly once its ready. Go to its default IP address in a browser to enter in to the settings page. Cancel the automatic setup wizard and continue to manual settings.
Note the following settings, as could be located different places in different routers. Mine was all in Setup tab (D-Link)
1. Operating mode: NBN Gateway not ADSL router
2. Interface : WAN
3: Connection Type: PPPoE
4: Username: fibrexxxxxx@dodo.com.au (@dodo.com.au must be added)
5: Password: Password
6: Tick mark in Enable VLAN check box to enable it.
7: VLAN ID : 100 (You can find this number in the homepage of dodo gohub router settings says "connected via ppoe over vlanxxx" 100 is default I guess)
8: Apply and reboot router
9: Wait
10: Job done :-)
|
|
彼得猪回国（天津）感受 (2009-12-30) Melbourner1978 
发表于 2016-1-12 17:52
