|
此文章由 oldboy 原创或转贴,不代表本站立场和观点,版权归 oursteps.com.au 和作者 oldboy 所有!转贴必须注明作者、出处和本声明,并保持内容完整
本帖最后由 oldboy 于 2012-10-17 15:42 编辑
idog8818 发表于 2012-10-17 11:53 
里面有个设置叫做assign wan as lan什么的...点那个就行.这样一来wan不能拨号了. ...
THanks, I found it.
http://www.dd-wrt.com/wiki/index.php/Wireless_Access_Point
LAN Uplink Through WAN Port
If you use your DD-WRT router as a WAP only, you may use your DD-WRT router's WAN port to connect it to your existing LAN. To do this, you need to disable the Internet Connection and "Assign WAN Port to Switch".
Normally, the router does Layer 3 IP routing. but by "Assigning WAN Port to Switch," your DD-WRT router will bypass that functionality and just pass on the Layer 2 ethernet packets from your wired network to the wireless network and vice versa.
Alternatively, if you have a router that supports assigning the WAN port to the switch:
Setup -> Basic Setup -> Internet Connection Type -> Connection Type = Disabled
Setup -> Basic Setup -> Network Setup -> WAN Port -> Assign WAN Port to Switch
you can connect the WAN port as your uplink to your main router. All this really buys you is an extra port (4 available instead of 3), but why not? |
|