|
此文章由 dalaohu 原创或转贴,不代表本站立场和观点,版权归 oursteps.com.au 和作者 dalaohu 所有!转贴必须注明作者、出处和本声明,并保持内容完整
As it turns out, there are two built-in methods of reinstalling. One is the recovery partition. The other is Internet recovery. (Both require internet access, however.)
As part of Lion installation, a small partition of the drive is created which contains “Mac OS X Utilities”. This the same program that runs when you boot a Lion install disk directly, and which lets you restore from Time Machine, go to Disk Utililty, etc.
You access this partition by either holding down cmd-R during startup, or by holding down option and choosing the partition from among the bootable volumes. If you elect to install (or reinstall) Lion, the actual Lion installer is first downloaded from the internet; the computer then reboots to continue the installation.
If there is no recovery partition — say, for example, because you replaced the stock SSD a higher-capacity internal SSD, and it sees no other bootable partitions, when you hold down option at startup it will say “network install” and give you a popup to join a WiFi network. When you do this, it downloads the contents of the recovery partition to a RAM disk, letting you then use Disk Utility and/or kick off the Mac OS X installation process.
I’ll just repeat that again: the new MacBook Airs (and the new Mac mini) can, with a completely bare hard drive, go out on the internet and get what it needs to install the whole operating system. |
|