|
|
此文章由 killkat 原创或转贴，不代表本站立场和观点，版权归 oursteps.com.au 和作者 killkat 所有！转贴必须注明作者、出处和本声明，并保持内容完整
我的 linksys 刷了dd-wrt, 看了一下 wireless mode 有几个选择，你大概是需要 client bridge mode，不过我没用过。
Wireless Mode
The wireless part of your router can run in different modes:
■AP mode – This is the default mode, also called Infrastructure mode. Your router acts as an central connection point, which wireless clients can connect to.
■Client mode – The radio interface is used to connect the internet-facing side of the router (i.e., the WAN) as a client to a remote accesspoint. NAT or routing are performed between WAN and LAN, like in "normal" gateway or router mode. Use this mode, e.g., if your internet connection is provided by a remote accesspoint, and you want to connect a subnet of your own to it.
■Client Bridged mode – The radio interface is used to connect the LAN side of the router to a remote accesspoint. The LAN and the remote AP will be in the same subnet (This is called a "bridge" between two network segments). The WAN side of the router is unused and can be disabled. Use this mode, e.g., to make the router act as a "WLAN adapter" for a device connected to one of its LAN ethernet ports.
■Ad-Hoc mode – This is for peer to peer wireless connections. Clients running in Ad-Hoc mode can connect to each other as required without involving central access points. |
|
DIY雨水桶的水泥地 (2008-3-23) 花生 
发表于 2011-4-29 13:12
