|
|
此文章由 HWX 原创或转贴，不代表本站立场和观点，版权归 oursteps.com.au 和作者 HWX 所有！转贴必须注明作者、出处和本声明，并保持内容完整
FROM "SWIMMING POOL SAFETY BARRIER GUIDE & OPTIONS
To Australian Standard AS1926.1-2007 & BCA 2011"
The standard requires a 900mm non-climbable zone ( NCZ) to be incorporated into the safety barrier all around the pool perimeter. See Non Climbable
Zone below. With the introduction of the NCZ, it is now preferable for the horizontal rails of a boundary fence to be located on the neighbours side of the
fence rather than on the pool side. There are now no restrictions on the placement of objects on the adjoining property ie. sheds, trees, dog kennels and
BBQ's etc. Effectively what a neighbour does on their property will not affect compliance with AS1926.1-2007. See figure 3 on page 2 for options where
horizontal rails are on the pool side of the barrier/fence.
TYPICAL SAFETY BARRIER:- The minimum height of an
internal swimming pool barrier is 1200 measured on the
approach side (outside) of the barrier. Refer figure 1.
Where the barrier is to be installed on a slope and the
fence panels are to be stepped, attention to the distance
between the horizontal members of adjoining panels is
required.
A 900 NCZ between the horizontal rails on each panel and
1000 Min. to the top must be maintained.
GATES:- Gates installed in the internal barrier must be
self closing and self latching with a latch release 1500 high
and must open away (outward) from the pool. |
评分
-
查看全部评分
|
在Perth买房子——接触Financial Broker (2008-9-4) Perth-newcomer 
发表于 2023-3-24 10:27
