|
Cisco 1841, G703 interface, e0的绿灯常亮， part of sh run: controller E1 0/1/0 framing NO-CRC4 Australia channel-group 0 timeslots 1-31 ! interface Serial0/1/0:0 no ip address no shut encapsulation frame-relay IETF frame-relay lmi-type ansi ! interface Serial0/0/0:0.16 point-to-point ip address 10.231.7.70 255.255.255.252 frame-relay interface-dlci 16 IETF 然后interface 就不停的这样变化：Router#sh ip int br Interface IP-Address OK? Method Status Protocol FastEthernet0/0 unassigned YES NVRAM administratively down down FastEthernet0/1 10.231.7.86 YES NVRAM administratively down down Serial0/0/0 unassigned YES NVRAM administratively down down Serial0/0/0.16 10.227.46.10 YES NVRAM administratively down down Serial0/1/0:0 unassigned YES NVRAM up down Serial0/1/0:0.16 10.231.7.70 YES manual down down Router#ping 10.231.7.69 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.231.7.69, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) Router# *Dec 9 08:12:33.811: %CONTROLLER-5-UPDOWN: Controller E1 0/1/0, changed state to down (LOS detected) *Dec 9 08:12:35.811: %LINK-3-UPDOWN: Interface Serial0/1/0:0, changed state to down *Dec 9 08:12:42.811: %CONTROLLER-5-UPDOWN: Controller E1 0/1/0, changed state to up *Dec 9 08:12:44.811: %LINK-3-UPDOWN: Interface Serial0/1/0:0, changed state to up *Dec 9 08:12:49.059: %CONTROLLER-5-UPDOWN: Controller E1 0/1/0, changed state to down (10 SES) *Dec 9 08:12:51.059: %LINK-3-UPDOWN: Interface Serial0/1/0:0, changed state to down Router#sh ip int br Interface IP-Address OK? Method Status Protocol FastEthernet0/0 unassigned YES NVRAM administratively down down FastEthernet0/1 10.231.7.86 YES NVRAM administratively down down Serial0/0/0 unassigned YES NVRAM administratively down down Serial0/0/0.16 10.227.46.10 YES NVRAM administratively down down Serial0/1/0:0 unassigned YES NVRAM down down Serial0/1/0:0.16 10.231.7.70 YES manual down down [ 本帖最后由 keke 于 2010-12-10 21:29 编辑 ] |
