|  | 
此文章由 nancy.ma 原创或转贴,不代表本站立场和观点,版权归  oursteps.com.au 和作者 nancy.ma 所有!转贴必须注明作者、出处和本声明,并保持内容完整 
| 收到一些问询,现把2个工作的具体职责上传,第一个要求比较高,大家可以看出来,需要有非常强而且相关的经验,必须是制造业-炼油业的相关process safety的经验,所以,不符合条件的同学就不要给我发简历了哈。第2个相对junior一些,不好意思上次没有把要求传完整,这次都帖上来了,毕业生肯定不行,需要有经验的。 
 1, Process Safety Manager
 Delivering on process safety expectations is a critical success factor for the company and
 in response this role has been set up to ensure that process safety is given the highest priority.
 The Process Safety Manager will play a key role in establishing and maintaining process safety
 expertise for the site, in setting up process safety management systems, in the implementation
 and assurance of standards as well as in coordinating technical advice and input to the Site.
 Duties
 The Manager Process Safety will:
 • Provide the leadership and technical competence to drive process safety management
 focus, principles and practices within the sites.
 • Embed global process safety related policies, standards, organisational guidance and
 tactics into the two sites.
 • Network with the Process Safety team in DSM and Process Safety Assurance organisation
 in the company’s Global Solutions team to share/implement good process safety practices.
 • Connect sites into the East Process Safety Network.
 • Work with the leadership team to implement recommendations affecting process safety management
 systems that include HEMP, Process Safety Reviews, Process Hazard Analysis and
 Learning From Incident (LFI).
 • Provide expertise and technical assurance on HEMP and contributes the same to other
 process safety critical processes.
 • Provide process safety assurance to sites by setting up adequate monitoring,
 health check and audit systems.
 • Develop, populate and maintain process safety performance metrics and KPIs.
 • Identify gaps in process safety robustness and drive process safety improvement
 programmes through BIP tactics.
 • Ensure consistent development and maintenance of process safety critical documentation
 such as safeguarding memoranda, area classification documentation, plot plans, etc.
 • Maintain skills to support and facilitate HEMP/LOPA processes.
 • Provide support for project justification through the application of ALARP/LOPA
 analysis.
 • Coach and verify technical safety contributions.
 • Coach and develop staff.
 Dimension
 a)        Provision of technical support and
 assurance across the whole of the sites.
 b) Site Focal Point for HEMP.
 c) Contributor to Process Safety networks.
 Key challenges are to make process safety more visible at sites, to raise the level
 of capability in the organisation to identify, analyse and address process safety risks, to
 implement standardised processes and provide assurance for these. Having material impact to
 help the site lower the number of process safety incidents and to reduce the potential for such
 incidents is paramount.
 Challenge:
 Chemical engineer or similar background. Prior manufacturing experience (minimum 5 years)
 is strongly desired as is broad knowledge of refinery processes. Expert knowledge of and
 experience in the application of (technical) process safety standards and systems is needed.
 
 [ 本帖最后由 nancy.ma 于 2012-3-19 12:52 编辑 ]
 | 
 |