|
|
此文章由 frank57 原创或转贴,不代表本站立场和观点,版权归 oursteps.com.au 和作者 frank57 所有!转贴必须注明作者、出处和本声明,并保持内容完整
google一下出来好几个,基本上是一样的。不确定是北美版的civic还是欧版/澳版的civic
1) Turn Ignition to On, but do not crank car
2) Within 10 seconds, press and hold the valet button (Slim button b/w the AM-FM and CD-Tape buttons)
3) While holding valet button, listen for the door actuators to activate
4) Continue holding the valet button and press a button on your remote
5) Still holding valet button, lister for actuators to activate again
6) While holding the valet button, turn the key all the way back (off)
8) When the car is turned completely off the radio may flash (the screen would have been blank the whole time)
7) Remove key and test remote
REMEMBER: You cant let go of the valet button at all during the process.
千万注意:
The system accepts up to four transmitters.
Entering the programming mode cancels all learned transmitter codes, so none of the previously
programmed transmitters will work. You must reprogram all the transmitters once you’re in the
programming mode. |
|