|
|
此文章由 dabaodedouzi 原创或转贴，不代表本站立场和观点，版权归 oursteps.com.au 和作者 dabaodedouzi 所有！转贴必须注明作者、出处和本声明，并保持内容完整
本帖最后由 dabaodedouzi 于 2022-3-10 13:45 编辑
actronair 空调不出冷风了
开机后 室内出风 控制面板显示run 的一直在flashing
然后之前是 开机一瞬间 外机会有三秒的压缩机启动声音 而现在 没有出现了
等大概2分钟左右 run不在闪烁 室内出风 室外风扇运转
猜测大概是softstarter或者capaciator坏了
电话了 actronair 他们也是说可能是这两个东西其中的 不工作了
自己有做了两次 power cycle 把外机外的 大旋钮switch 调到 off 然后等待30秒 和 一次3分钟
回室内 重新开机 依然无果
有没有高手 又遇到过同样的事情
这个soft start还不便宜 Google 了一下 600 左右光parts
以下是找到相关文件
How to Reset Your Actron Air Conditioner
The best first step is to reset the system.
Locate the switch on your electrical isolator. The electrical isolator switch can be located next to the outdoor unit. Or, if you have an older system, it may be found in the electrical meter box.
Please turn it off for at least 30 seconds.
Switch it back on.
Try turning the system on again and wait 10 minutes to see if the issue resolves.
whirlpool一个哥们说
Having worked with Soft Starters and VFD's for a long time in industry, you would be surprised how many times a fault can be cleared by a power cycle. Try that first, then if the fault leds either keep flashing, or restart flashing at the next start command, there is something else going on. My gut feeling is that the starter may be seeing a motor fault, short or open circuit, seized etc. Give the power cycle a go first, unless you have tried that.
出处https://forums.whirlpool.net.au/archive/9rvjwvnv |
|
补习班颁奖之杂七杂八（2011年11月20日更新） (2009-11-22) patrickzhu 
发表于 2022-3-10 12:25
