新足迹 › 论坛 › 澳洲生活区 › 我爱我家 › 烟雾报警器 HPM 645/3 电池更换相关信息

精华好帖回顾
· 豇豆 (2016-11-10) qld	· 花鸟画 (2008-10-21) 净心
· 偶家饺子制作全过程-已更新，完全版！ (2005-6-5) 溪霓冬雪	· 儿时的最爱--椒盐酥皮点心 (2009-1-10) little_bw

查看: 3203|回复: 1

[其他信息] 烟雾报警器 HPM 645/3 电池更换相关信息 [复制链接]

scorpiusd

银靴族

发表于 2018-1-29 00:59 |显示全部楼层

此文章由 scorpiusd 原创或转贴，不代表本站立场和观点，版权归 oursteps.com.au 和作者 scorpiusd 所有！转贴必须注明作者、出处和本声明，并保持内容完整

Whirlpool 的信息

http://forums.whirlpool.net.au/archive/2575333

magpole
I actually removed the unit from the hinge, and was able to pry the battery out easily with a pair of needle nose pliers. Anything would have worked though, you just need to lift the end of the battery up and it comes out easily.

So to follow up. Definitely easier to remove the battery when the unit is detached from the hinge. Also, don't forget to discharge any residual power and reset the unit while the battery is removed. Hold the test button for about 15 seconds. I didn't do this and had to figure out why the units kept chirping even with a new battery!

Legrand 关于该烟雾报警器的文档

http://www.legrand.com.au/upload ... uction_Sheet_01.pdf

参见第二页最后一部分

当烟雾报警器每 60 秒响一次的时候代表该换电池了

If the unit gives a chirping sound every 60sec the battery may need to be
replaced.

电池型号如下

USE ONLY THE FOLLOWING 9-VOLT ALKALINE BATTERIES FOR
REPLACEMENT: EVEREADY/ENERGIZER 522 DURACELL MN1604, MX1604

更换电池的说明

BATTERY REPLACEMENT

To replace battery, unlatch unit from mounting base and remove the battery from compartment. Replace the old battery with a fresh one and close unit. Verify that the green LED is on.
To ensure proper operation, the battery should be replaced once a year.
Smoke alarm cannot be closed properly without battery in place.