|
|
此文章由 kaiak 原创或转贴，不代表本站立场和观点，版权归 oursteps.com.au 和作者 kaiak 所有！转贴必须注明作者、出处和本声明，并保持内容完整
Setting up wireless controls
Wireless controls can operate the opener, or the opener's courtesy lamp, by sending coded radio
signals. These coded signals use high-security code-hopping.
Wireless controls can be hand-held or fixed to walls, such as a wireless keypad, or a wireless wall-
switch.
Up to 20 Merlin wireless controls can be learned by the opener. After this, the 20th wireless control
is over-written in the opener's memory.
All wireless controls can be deleted from the opener's memory.
There is a red learn button under the green control panel cover on the front face of the opener. The
small button on a Merlin M-122 wired wall-switch can also be used as the learn button.
If a setting is enabled in the opener, then it is possible to use any existing learned wireless control
as a learn button. (See separate section following.)
To learn a remote button to operate the opener:
Press the learn button for 1-2 seconds, until the courtesy lamp begins to flash slowly.
Press the desired remote button, wait 1 second, press the desired remote button again. The cour-
tesy lamp will stop flashing once learning is complete.
To learn one remote button to operate the opener and another to operate the lamp:
Press the learn button for 1-2 seconds, until the courtesy lamp begins to flash slowly.
Press the desired remote button for control of the opener, wait 1 second, press the desired remote
button for control of the courtesy lamp. The courtesy lamp will stop flashing once learning is com-
plete.
To delete all remote controls from the opener's memory
Press and hold the learn button for eleven seconds, until the courtesy lamp stops flashing. After six
seconds it will flash fast as a warning. If you release the learn button during this warning period
then the memory will not be wiped |
评分
-
查看全部评分
|
蔡康永——《那些男孩教我的事》 (2004-12-13) 蜻蜓 
发表于 2018-1-22 15:01
